looks this image bright and normal according what you have seen sofar with you friends
Latest posts made by doebro2010
-
RE: Resolution problem
-
RE: Resolution problem
it uses my 1080TI where do I have to put off scaling? and how do i get the right resolution if fullscreen brings the resolution down as you could read in previous remaks
-
RE: Resolution problem
i want to send you a screenshot made it in jpeg and png but during upload got the message upload or file failed. do you have an idea what it could be?
-
RE: Resolution problem
I already have changed it according your previous suggestions so if I understand you correctly, I can use (alt enter) to fullscreen and what is mentioned in the output is not interesting to watch at.
the monitor will show the right resolution.
Rest me to thank you a lot for supporting me.
see you hopefully in the next roundb.t.w do you use nvidia inspector or nvidia controller.
-
RE: Resolution problem
current is says 3840x2160(32bit)60hz
native is 3840x2160§ 60hzwhat I discovered is: switching to full screen (by alt enter) set the output on 1024x768 automatically.
switch in the grafics to borderless does do the settings change to 3840x2160 automatically.
but I can not do anything then in the small sized block . so I have to go out and start again, the setup is then available again in a small way but touchable and the setting is still 3840x2160.
obviously there is a strange behave in the output grafic.
following advice via nvidia settings did not help to get a better size, only with alt enter but as said before the output will switch back to 1024x768. -
Resolution problem
I am new here and have a problem which I also put in the general forum.
got a message there: to feel free going the technical support.
I have a problem under the setting by grafics.
the first line I can choose: window, borderless or full screen
the next is output which shows me first one line 2540x1440
while the resolution line below this one, let me choose 3840x2160 which is my native.so I deleted everything and started from scratch and then the output line was the same as my resolution.
But when I started the game again there was suddenly in the output 1024 x etc.
so I dont understand it anymore what is going wrong
Any of you who can help me out? -
Install problem
I have in the past installed falcon 4 with bms before and didnot have a problem
Today after some time I would start again.
But after falcon4 ,Iread a lot over installation but I cannot get it done.
After 4.33.1 downloading and so on I still got the message
The registry entry pointa to a folder that doesnot contain a valig falcon 433 install.
I also went to the registry and deleted some old stuf but nevertheless
it wont work.
I also skipped the norton for a short time ,no luck
any idea what I can do more.duke
-
Speed brakes
after a year spending abroad I returned now and would like to startup to join falcon bms.
trying to study the sartup of the viper I have a question.
I have a G940 logitech and appointed butten P3and P7 for speedbreak open and close.my question is, if I push the button open does the speedbrake does it job or do I have to toggle another button as well.
kind regards
Duke