About throttle response at taxi
-
Hello.
There are no response of throttle when that have hold short on the run way end.
This problem have been happen when had released “Alt+a” key.
In my case, I have noticed this problem, because of Paddle switch has been Assigned to Wheel Brakes.
(Normal Paddle/S4 have been Assign to APOverride “Alt+a” in 4.33)This during " FUEL FLOW INDICATOR " (Throttle position Idle)
Problem case [000.00] PPL
Normal [011.00] PPLAt this moment, I am avoiding the problem temporarily in the following kye profile.
Paddle/S4 (…and so on…)
SimAPOverride 3 -1 -2 0 0x0 -1 <— comment out
However I hope to used APOverride at Paddle.
Is there a good way?best regard.
-
Good way is to use Dunc_DX files (\Falcon BMS 4.33\Docs\Key Files & Input\Dunc_DX) if you have Cougar HOTAS.
Dunc_DX uses S4/Paddle switch for both wheelbrakes and AP override at the same time.
-
Thank you reply
Even if Dunc_DX files use, It will occur in the same way.
This problem essence have been happen when had released “Alt+a” key.best regard.
-
I’m also having sometimes trouble with syncing the throttle in game. At that point I can slowly move up my throttle to full AB and moving. But
when I bring it back down, it starts firing up the engine…
appears to be happening only during TAXI (both before and after flight). In flight it seems to be just fine.
I too use Dunc_DX which uses the paddle for breaking.Any suggestions? Is this a known problem?