Mission Training ILS Landing
-
The F16 model in this training mission is an F-16DM-40. It has no Instr Panel so how do you switch from NAV to ILS Mode to activate ILS bars on HUD and ADI ?
I read again and again the manuel but i don’t find the answer.Thanks for helping
-
Press on the M which is located in the middle of the pit all the way down below the HSI.
-
Push the M button on the EHSI
You’re right I omitted that small detail change in the training manual ILS chapter.
I think though that I mention it in the dash 1, EHSI sectionedit grilled
-
@Red:
Push the M button on the EHSI
You’re right I omitted that small detail change in the training manual ILS chapter.
I think though that I mention it in the dash 1, EHSI sectionedit grilled
No you didn’t! I just did this mission today and used the training manual where the use of the M button was clearly stated.
PS. Thank you for the manuals, they are really really good! Especially the new air to air training missions are just what I needed to get back in to BMS. Thank you very much!