UNCAGE LGB
-
Please help me out
When do i uncage the missiles when using LGB- Is it before or after the 3 min time-out
Have been busy the last 2 days trying to use these things and only succeeded in wasting million of dollars to no avail
Yes, reading the manuals but wow maybe because i am not the sharpest guy on the block i am going to spend another 2 months figuring this little problem out(dropping LGB effectively)
And yes, there are lots of youtube videos out there as well, but with my third world internet speed it is a no-go here in South Africa -
did you switch to COMBAT mode ? check HUD it may still be on TRAINING…… just a thought.
-
Yes ,switched to combat mode
-
I think you mean how to get the image on theTGP.
The LGB does not need to be uncaged because it is not a maverick or an IR missile.
When you do your ramp-start, after engine is OK and after the normal checks, switch mastermode to A-G, select the TGP on one of your MFD, hit the OSB1 (STBY) and then you will see A-G near OSB6.
Hit OSB6 and wait untill “not timed out” will desappear and the image of where TGP is ponting on groud will fill the MFD. Normally, the ground at selected STP .
Of course, Master Am ON, laser to combat mode and same laser code on UI loadout screen and ICP.
Would you please refer to BMS Training manual, mission 11 LGB or the -34 at Sniper X session.
Hope this help -
I do get the picture, master arm is on, laser is in combat mode
My problem is if i designate a building in the picture there is no cue running down the HUD to tell me when to release the bomb -
Can you check what your “angle of impact” is set to in the SMS page? I have noticed that you don’t get a cue if you have it set to 0 (may even be any value lower than X, though I haven’t extensively tested that myself yet).
-
I do get the picture, master arm is on, laser is in combat mode
My problem is if i designate a building in the picture there is no cue running down the HUD to tell me when to release the bombAlso no countdown to release in hud lower right ? You are on ccrp mode ?
-
I do get the picture, master arm is on, laser is in combat mode
My problem is if i designate a building in the picture there is no cue running down the HUD to tell me when to release the bombAre you able to drop a normal unguided bomb in CRRP mode? Because the actual dropping of the LGB is really pretty much the same as that.
-
Screenshots or a video could save you some time.