Horrible FPS
-
As others have said, what exactly are you getting in terms of FPS numbers? What mission/scenario is this? What resolutions are you running at?
If you check out my FPS Testing thread, I have a 980Ti running on an extremely taxing mission and pushing 4 screens from a single card. You should get better numbers than I am even on a 980 if you are running single screen.
-
I used Fraps to test FPS while running minimum and maximum settings and found something rather curious. It seems to be locked at 30 FPS. Even if I go into Nvidia inspector and lock it at something like 60 FPS (my monitor’s refresh rate) and the FPS doesn’t seem to change no matter what. Is there some FPS limiter internal to the game that I can set?
-
I used Fraps to test FPS while running minimum and maximum settings and found something rather curious. It seems to be locked at 30 FPS. Even if I go into Nvidia inspector and lock it at something like 60 FPS (my monitor’s refresh rate) and the FPS doesn’t seem to change no matter what. Is there some FPS limiter internal to the game that I can set?
vSync on?
Also, there is a frame rate lock in the FRAPs settings …. 30, 45, and 60 I think.
In-game FPS counter is probably better. 4.33.1 default is, I think, ALT-C, release, then F.
-
Hi all! Super excited to get started with this game but also super frustrated. I am getting very poor FPS even with my settings turned down. I am running a GTX 980, an Intel 4790K and 16GB of RAM, so it’s not a low end system. Any ideas on what might be causing this?
Thank you!
What ever the problem it is defiantly NOT in the in-game settings.
The only thing which might have a slight effect on your system would be BMS Display Extraction. And if you have turned up the trees & grass sliders.
So leave all the in-game options as they were by default.
It must be a problem with your Install or GPU drivers.
Are you running on a 4k monitor?
I see, are you using a HDMI cable ? -
I am using a 1920 by 1080 monitor with a HDMI cable. And with the BMS fps counter I still get the same result. I also installed the latest Nvidia driver, to no effect.
-
vSync on?
Also, there is a frame rate lock in the FRAPs settings …. 30, 45, and 60 I think.
In-game FPS counter is probably better. 4.33.1 default is, I think, ALT-C, release, then F.
It’s not a “frame rate lock” What you are seeing is the Frame Capture Rate. FCR not FPS
-
I am using a 1920 by 1080 monitor with a HDMI cable. And with the BMS fps counter I still get the same result. I also installed the latest Nvidia driver, to no effect.
Is it only Falcon that is suffering?
Do you have a DVI or VGA cable you cant test with ?
-
If V sync is on it maybe limiting framerate to half your monitor refresh rate. check in Nvidea inspector. I believe you definitely should be getting a higher framerate than what you are seeing.
-
Thanks sub 101! That did the trick. I’ve still got to do optimization, but I’m on the right track now. See you in the sky!
-
Thanks sub 101! That did the trick. I’ve still got to do optimization, but I’m on the right track now. See you in the sky!
Glad that you are on the right track now. what you need is a setup which is stable, I have limited my fps to my monitor refresh, which is plenty I then configured NVidea inspector to app controlled. used v sync to stop tearing. my fps are now fairly stable. ie 60 down to 40 when very busy. I don’t think a fps above 60 is any advantage really on one monitor. The best setup is to make your lowest fps playable.