Looking for Call back Key
-
I was wondering what the callback key is for Bore Sight
Thanks
-
SimCursorEnable (ideally will be a HOTAS command) selects Bore from Slave when held, or OSB ?18 in the SMS page.
-
Sry for stealing thread, but something related is bugging me.
Most of the times (because of microstick’s small deadzone) I accidentally move microstick a bit when pressing SimCursorEnable for a offboresight no-radar 9x shot…
Now, does the radar really turns ‘ON’ , by that small movement of microstick at that point ? (which is bad for me , revealing my posit)
Because ‘NO RAD’ mnemonic dissapears and boresight radar cross appears on the hud at that moment … but no radar lock occurs.?Thanks in advance
WFedit:
I’ve managed to test somehow…
Yes, it does turn on radar if held SimCursorEnable and moving microstick to any side even by a small movement. (radar cross appears on hud)
It is a problem however described above, spoiling your surprise attack by radiating.Fix would be enlarging microstick’s deadzone even more , but that have impact on its sensitivity and movement range, but need to test how much, could be that is bearable, in tolerance.
Is there a way to disable such behavior on SimCursorEnable in BMS, to disable turning on radar by accident, not just by enlarging deadzone (other then foxy/hotas-cp programming) ?
-
There is also a bore/slave toggle listed under the “Shortcuts” section of the keyfile;
SimToggleMissileBoreSlave
-
There is also a bore/slave toggle listed under the “Shortcuts” section of the keyfile;
SimToggleMissileBoreSlaveSimToggleMissileBoreSlave is function slaved to held button SimCursorEnable , and are related but are not the same. Dash -1 manual.
Regards
WF