Nooby - Warthog Question
-
yes it is possible to not use target, can’t see the point though as target is easy to use and you can set the LED’s easy. I have set all the devices dx buttons for what I want. the switches which are not dx are set in target using the keyfile keystroke. This way I have not even needed a shift layer.
-
That’s what I meant, if you want to use all switches, so full functionality, you have to use Target. Correct?
Send from my Xperia X using Tapatalk
-
Thanks for the assistance. I’ll try to use Stubbies recommendation as I’ve already spend considerable time programming the keystrokes through TARGET. I’ll try to figure out the BOAT switch to enable shift layering for multiple uses of buttons for NAV, A/G and A/A modes. I’d prefer to do this and keep things simple. If problems arise, I’ll check into using another’s profile (like MUD) and use the key editor. As an aside, I did play this game years ago. Switched to FSX. Now back to Falcon BSM due to the campaign action and dynamic AI. Here we go again on the learning curve - should be fun though.
-
boat switch was easy bsf A-A Bsm NAV bsb A-G. therefore in mid position it is on nav when moved forward it selects A-A. when you select back to mid Nav gets selected. the select it back and A-G mode is up All done with pulse. Use a spring return toggle switch and Led if you want layers or shifts.
-
That’s exactly what I want. I’ll try it. Sub101 - do you remember the keystrokes you programmed for this button - to do the layering?
-
let me have a look at my warthog profile. Okay for a layer I have used spring return toggle eorign, which give me I/o layers. For U M & D I have used psf psm & psb, I have ground ops set to D option. I can send you my profile and keyfile if you want to use as a reference. for l layer I have comms datalink set whilst in OM layer the same switch does hsd range increase.
-
You can use all buttons if you operate the stick and throttle as separate devices.
All the best, Uwe
-
Hoover - I tried yesterday to use the joystick independently and not use Target - Falcon did not recognize that I had a joystick connected. Everything was in keyboard mode only. I’ll check into it more this weekend as I feel like I’m taking a somewhat helter-skelter approach to my setup, you know, try this, try that, etc… Sub101 - if you could send me your profile and keyfile, that would be a much appreciated head start for me.
-
You can use all buttons if you operate the stick and throttle as separate devices.
I took a long look at it tonight. Some two-way switches only give output in one position, some three-way switches have only two positions with outputs. So if I understand correctly, it’s necessary to use the release-button dx-setting. But this also means the Warthog switch position will not always be corresponding with the cockpit switch since there is only a release command (which will not be there if the switch is already in that position). Am I correct? And if yes, is there a work around?
Meanwhile I’m still trying to figure out the keyfile editor[emoji27]
Send from my Xperia X using Tapatalk
-
Hoover - I tried yesterday to use the joystick independently and not use Target - Falcon did not recognize that I had a joystick connected. Everything was in keyboard mode only. I’ll check into it more this weekend as I feel like I’m taking a somewhat helter-skelter approach to my setup, you know, try this, try that, etc… Sub101 - if you could send me your profile and keyfile, that would be a much appreciated head start for me.
pm me with an e-mail address and I will send it straight away.