Hi, I have this error - Interior and exterior view dont match. Please help
-
Hi,
I have this error and would greatly appreciate any help.
“Search” in forum did not find any posts for error.
Here goes:
With basic BMS433U3, I tried running “Carrier Landing” training mission.
In flight, I had an F16 cockpit, but an AWACs exterior.
I exited TE, and I chose “only F16s” in “configuration”, but the f16/awac problem persisted in TE training for “Carrier Landing”.
Other missions run ok.Thanks for any help.
Roger. -
Hi,
I have this error and would greatly appreciate any help.
“Search” in forum did not find any posts for error.
Here goes:
With basic BMS433U3, I tried running “Carrier Landing” training mission.
In flight, I had an F16 cockpit, but an AWACs exterior.
I exited TE, and I chose “only F16s” in “configuration”, but the f16/awac problem persisted in TE training for “Carrier Landing”.
Other missions run ok.Thanks for any help.
Roger.Before clicking fly , choose a f18 flight in the mission window
-
Before clicking fly , choose a f18 flight in the mission window
Hi,
Thanks for reply.
But I cant find mission window on Training page.
See attached pic.
Nothing I click on is opening a mission window.
TE builder opens, but that is for new mission, not the carrier landing.
Roger. -
Click on commit at bottom right corner. Then selections will be presented.
After selections select fly at bottom right corner.sent from my mi5 using Tapatalk
-
Hi,
Thanks for reply.
But I cant find mission window on Training page.
See attached pic.
Nothing I click on is opening a mission window.
TE builder opens, but that is for new mission, not the carrier landing.
Roger.Launch the carrier landing mission then select f18 in the flight window
-
OK, thanks for all the help.
Found it.
Choose “Carrier Landing”, then click “Commit”.
In Mission window, choose “Training”, then click on aircraft below to change pilot.
Then choose “Takeoff” to fly F18.
The AWACs is the default plane in the mission.