65f radar cursor drift
-
When using an axis or keystroke mapped the gate just keeps moving.
Thoughts?
-
That was happening to me with the microstick on my Cougar. I adjusted the deadzone and curves to fix it.
-
Increase the deadzone in BMS.
Ive seen a few reports years ago about not using the windows calibration tool for the axis, as apparently its permanent? I cant recall it, I remember struggling with it for ages before applying the deadzone in BMS.
Problem solved (with the minor irritation that the stick has a deadzone, which I dislike). Problem was even more solved once I upgraded to a Cougar.
-
When using an axis or keystroke mapped the gate just keeps moving.
Thoughts?
I had to increase the deadzone in BMS Advanced Control Settings to maximum. Then it stopped wandering around.
-
When using an axis or keystroke mapped the gate just keeps moving.
Thoughts?
Mower, I used to have this problem. I just jumped over and looked at my -65’s SST, and confirmed I did set the cursor via the BMS UI. I used the “DX” method
One thing you might try is to remap the keystrokes so they are not what I call combo keystrokes. For example, cursor right is “.”, not shift + arrow right. BTW,I did the same to the “critical controls” like TMS. I have had -65 problems in the past with combo keystrokes -
Ive seen a few reports years ago about not using the windows calibration tool for the axis, as apparently its permanent? I cant recall it,
Diview
-
Mower, I used to have this problem. I just jumped over and looked at my -65’s SST, and confirmed I did set the cursor via the BMS UI. I used the “DX” method
One thing you might try is to remap the keystrokes so they are not what I call combo keystrokes. For example, cursor right is “.”, not shift + arrow right. BTW,I did the same to the “critical controls” like TMS. I have had -65 problems in the past with combo keystrokesThis worked. Thanks.
-