Cursor zero doesn't reset
-
I had the same problem. Enlarging the dead zone on the cursor axis resolved since it continously gave very small inputs but enough to move the SPI away from its original position.
-
just wondering if this is a new feature of the updates because in the past I used to click on CZ on the FCR and it went back to the original waypoint but now while I can reset it in HSD page it doesn’t seem to reset in FCR page or TGP page
Maybe you have “locked” target in TGP…, TGP shouldn’t be in grnd-stabilized mode. (point/area track), UNdesignate target first…(TMS-down), then CZ
Cheers
-
I had the same problem. Enlarging the dead zone on the cursor axis resolved since it continously gave very small inputs but enough to move the SPI away from its original position.
I thought it would be that too. I tried dead zone zero & small but same effect no change! I’ll try large
-
I had the same problem. Enlarging the dead zone on the cursor axis resolved since it continously gave very small inputs but enough to move the SPI away from its original position.
yep, that was it. With TUSBA it should be set to large dead zone. By the way did you have any issue wiht sounds too. When I lower the volume on UHF or VHF it work fine but after a little while the sound is maximum even when the knobs are turned down! is that U1 glitch?
-
Good!
No issues with sound here but I must say that aside for turning up at ramp I don’t touch any volume knob during flight… -
yep, that was it. With TUSBA it should be set to large dead zone. By the way did you have any issue wiht sounds too. When I lower the volume on UHF or VHF it work fine but after a little while the sound is maximum even when the knobs are turned down! is that U1 glitch?
Sound: external views.
-
Sound: external views.
you mean if I go to external view then go back in cockpit then the sound will go up?
-
you mean if I go to external view then go back in cockpit then the sound will go up?
yes. the audio knobs positions are not saved in cockpit defaults either. work around: 1 left click and 1 right click on every audio knob after every external view
-
yes. the audio knobs positions are not saved in cockpit defaults either. work around: 1 left click and 1 right click on every audio knob after every external view
that did it
-
This post is deleted! -
Maybe you have “locked” target in TGP…, TGP shouldn’t be in grnd-stabilized mode. (point/area track), UNdesignate target first…(TMS-down), then CZ
Cheers
Yes. That was my problem with CZ.