DISPLAY EXTRACTION
-
<p>Just installed 4.35, U1, and U2. How do you set the display to be in the center of your monitor. I don’t see display extraction on the main menu that launches falcon.</p>
-
<p>@asw200 <br /><br />Could you stop writing titles in caps?<br /><br />You already asked and you already got a reply.<br /><a href=“https://forum.falcon-bms.com/post/339560” target=“_blank”>https://forum.falcon-bms.com/post/339560</a></p>
-
<p>ok ! but I was watching Max Waldorf video on how to install bms 4.35 that’s where I got the display extraction question from. As for as the question being answered i did not look at the second part of my post. forgive me!</p>
-
<blockquote>set the display to be in the center of your monitor</blockquote><p><br />Display Extraction / RTT is a somewhat advanced setup. I recommend you get 4.35 with all 3 updates installed and working, and practice flying with that, before taking further steps to fine-tune RTT setup.<br /><br />But actually I’m not sure what you’re asking, when you say “center of monitor”.<br /><br />Are you asking, how to move the 2D menu/setup screen, from the upper-left corner to the center?</p>
-
<blockquote>Just installed 4.35, U1, and U2. How do you set the display to be in the center of your monitor. I don’t see display extraction on the main menu that launches falcon.</blockquote><p><br />At a loss as to why you would not install U3 also? You seem to be confused as to what “Display Extraction” actually is. You can “extract” certain gauges and the MFDs to be “displayed” on the main or secondary monitors. It has absolutely nothing to do with the 2D or 3D Falcon 4.35 screens… Below is an example of “Display Extraction” using Helios, though the MFD’s can easily be extracted using the included RTTClient app…<br /><br /><img class=“ql-image” src=“https://i.imgur.com/gEOYlKM.jpg” /><br /><br /> <br /></p>
-
<p>Yes I used the wrong terminology for what i was asking. Yes all I wanted to do is move the intro screen from the left corner to the middle of the screen when it launches. RTT came from my original post looking for display extraction on the menu bar when installing 4.35. I didnt install U3 because i wasnt shore how to accomplish the work around successfully and not screw up the install.</p>
-
<p>@asw200 hit [Ctrl+Enter] to switch from borderless to windowed mode – this will give you a draggable titlebar on the 2D screen<br /><br /><br />Then [Ctrl+Enter] again to switch back to borderless, before launching into 3D world<br /><br /></p>