Solved HARM WPN POS steerpoint not updating once threat type is selected
-
Doing the TR_BMS_12_HARM training mission, practicing POS EOM mode I’ve noticed that once I’ve selected a thread on the WPN page with OBS 16-20, my steerpoint for the selected AGM 88 station (below the LSDL) will no more update as I change SPI, once I unselect the threat, all is good. I guess that’s not a feature
-
@Jetsun TMS AFT to remove the HANDOFF. Then you will be able to change the POS STP via the ICP.
This was added so you have the ability to pre-programm a dedicated STP for each HARM station in addition to mode,table,etc… -
@Jetsun For me it’s a feature. There is a delay to send the data to the AGM-88 once you select a threat type, doing a sort of hand-off. Once the Harm as memorized all the settings (stp, threat, Mode, GS, TI, …), i think you must clear it before redoing the process.
But perhaps am i wrong ?My Best,
Eric. -
@ericfa2a, idk either, but seems a quite error prone behavior for headless like me, I’ve just checked in 4.35u3 and the WPN steerpoint is being updated whether or not a thread have been selected beforehand.
-
@Jetsun Did you check the MFD for a “Headless Mode” on the Weapon Page…?
-
@Aragorn damn, that’s where a real head would have been useful.
-
@Jetsun TMS AFT to remove the HANDOFF. Then you will be able to change the POS STP via the ICP.
This was added so you have the ability to pre-programm a dedicated STP for each HARM station in addition to mode,table,etc… -