Solved A-G Mode -unable
-
A-G mode. For months now i have been unable to get a bomb to drop. it seems i cannot get into A-G mode via the cockpit with mouse, or the TekDesigns ICP. the button is mapped and responds in Setup like all the buttons. I load up some bombs take off and cannot switch moded to A-G. was hoping this latest version 4.36 would help. Maybe the Device Order cfg. definitely bummed no bombs.
-
Hi there, can you make a video ?
-
@windnc60 can you clarify … you had this problem in both 4.35.3 and in 4.36?
and the keyboard binding [F6] also doesn’t work?
-
I’m not sure that I fully understand your problem.
AG mode , or bombs do not leave the plane when asked ?This seems so isolated case that, for what is worth, I would suggest reading the manual fully , also device setup configuration, then along with training mission with air to ground content.
-
I would assume the Missile and Dogfight overrides are the culprit here. As I tried it this morning i brought it out of “override” and the RT MFD switched to A-G mode when I pressed the A-G button on the ICP. Go Figure, Many thanks to all.
-
-
@windnc60 said in A-G Mode -unable:
I would assume the Missile and Dogfight overrides are the culprit here. As I tried it this morning i brought it out of “override” and the RT MFD switched to A-G mode when I pressed the A-G button on the ICP. Go Figure, Many thanks to all.
That sounds reasonable. That’s why they’re called ‘override’ functions. I think it’s in the User Manual when crafting a TE that you set up your A-G parameters once airborne, then engage Missile Override until you reach the target IP.