Solved manual trim test and stores jettison issue
-
It seems i cant test the manual trim with rampstart, if i flip the switch to disc the needles still move if i move it with the stick. i also cant set up my stores jettisson, it looks like its not working anymore? anyone else had that issue?
-
@BVT_Gadget for SJ, make sure you set up the SJ mastermode in the DTC in 2D.
-
@BVT_Gadget Also note that as of (I think) 4.36 you cannot access S-J mode while in any other mastermode (ie. DGFT override) or while on the ground (WOW) without flicking “GND jettison enable” to ON
-
thanks for the help guys, that fixed the sj issue, now the only issue remains is the test of the manual trim
-
@BVT_Gadget are your bindings setup as “STICK: Trim x” or “TRIM: Trim x”? It works for me with bindings on the former, as it should disconnect the stick trim but not the manual trim wheels, which are the latter binding.
-
For the stick trim check that the callbacks in your key file are correct. The MAN TRIM panel call backs will seem like your trim is working but you will be using the panel to make trim inputs instead of the stick. This is why the disc switch will not stop the trim inputs during ramp start.
For the stick trim:
AFElevatorTrimUp
AFElevatorTrimDown
AFAileronTrimLeft
AFAileronTrimRightFor the Man TRIM panel:
SimTrimRollLeft
SimTrimRollRight
SimTrimYawLeft
SimTrimYawRight
SimTrimNoseUp
SimTrimNoseDown -
@TeeSquare i checkt the bms keyfile and i have this:
https://gyazo.com/d5b53bb282b8b788bac5776f08f0df08https://gyazo.com/97fc897c360d2c2abb0d1c8b510a6e86
but if i flip the switch to disc and move the trim on my stick the needles stillare going on the trim panel
-
The key file at your link has the AFE… call backs set to keyboard ctrl up, down, left, right arrows not dx buttons.
Try pushing those buttons and see if the needles move while the TRIM/ AP DISC switch is set to DISC.
You can program those to your HOTAS but that will cause you other problems. shifted keys get stuck on press and hold buttons.
You need to assign the AFE… call backs to your HOTAS stick trim button.
DX assignments look like this but your button numbers will vary depending on what order your devices are loaded in.
AFElevatorTrimUp 0 -1 -3 0 0x0 -1
AFAileronTrimRight 0 -1 -3 2 0x0 -1
AFElevatorTrimDown 0 -1 -3 4 0x0 -1
AFAileronTrimLeft 0 -1 -3 6 0x0 -1 -
@TeeSquare problem is fixed, thanks for the help , my dx was set wrong, now its good.
-
-
@javelin10 Yes. S-J Master Mode - S-J is selected/deselected using OSB 11 on any SMS MFDS page. If S-J is selected while in an override mode (DGFT/MSL OVRD), S-J will be entered
upon leaving the override mode.S-J while WOW has been fix in U2. S-J can be accessed while WOW or LG is down, and stores can be selected. GND JETT has no influence in regards to accessing S-J or selecting stores. If GND JETT is set to enable, the HOT mnemonic will be displayed on the MFD, and stores may be jettisoned.