BMS 4.36 U3 : Auto-Pilot No Effect.
-
hello ,
have the same issue .
rgds .
-
Really need a repro case to be able to investigate this further.
AP is working fine in TE, TR and campaign here.
-
@oneeast00 I ont have an issue with Ap, make sure you dont have a binding which is permanently keeping it disconnected. also it is bound by speed aswell.
-
-
no issues here
-
@oneeast00 I had this issue a few weeks ago. The switches in the cockpit would move, but with no effect. The problem seemed to happen randomly.
The solution was: I had configured the PADDLE SWITCH by mistake to another switch on my stick. So, by activating that one, the PADDLE SWITCH would always be active and AP would not work.
Check your buttons assignment configuration thoroughly.
-
Well we’re unable to reproduce so we’ll archive it and see if that pops up for future versions…
-
…I got this problem too…after recalibration of my stick the problem were gone? Perhaps this can help?
-
@Cop23rd said in BMS 4.36 U3 : Auto-Pilot No Effect.:
…I got this problem too…after recalibration of my stick the problem were gone? Perhaps this can help?
The AP engaged always offer the possibility for the pilot to use the stick
So if your stick has a non calibrated neutral position then AP will always deviate indeed
-
@Cop23rd said in BMS 4.36 U3 : Auto-Pilot No Effect.:
…I got this problem too…after recalibration of my stick the problem were gone? Perhaps this can help?
Obviously the AP doesn’t like inputs from stick…
-
everyone remember [alt+C][J] to recalibrate-center your stick, in flight
especially useful if you have deadzone=none for pitch/roll axes (for a nice light touch while doing aar)