Cougar Vipergear Hall Sensor Issues and ANT Pot issue
-
Hello!
Already tried to contact the Vipergear people!
I believe they could guide you!
Good landings! -
Yes but I wanted to see if anyone else has experienced this issue on here. It never hurts to ask. Thank you for your reply. Good Landings to you too!
-
I found that the distance between the sensor and the magnet makes a difference … could be you are not close enough… at least worth a try.
-
The sensor and magnet are off of each each by about 2-3mm. Any closer and they would be touching. Good thought though. Thank you.
-
Check the install guide for the stick kit. Also it sounds like the pot for the antenna on the tqs is shot. Is it the range pot or elevation?
-
I followed the install exactly how the stick kit install guide specified. I do know that this midlife upgrade has been sitting around for quite some time so the magnets may not have enough potency. I think I’ll just shell out for a new set. Vipergear has yet to respond three days after I sent the email out to them.
As for the pot, it is the ANT elevation pot. I think its shot too so a replacement fitting specifications of the original is on its way to me. The only difference being its a 305 deg pot instead of 270. I have it on good word though that the one I ordered worked perfect on another Cougar TQS from a friend.
Thank you Jumpstart5179.
-
check my super cougar write up there is a gentleman that is making elevation sensors now for the cougar. I am using his tqs hall sensor in mine.
-
Will do. Thank you!
-
The sensor and magnet are off of each each by about 2-3mm. Any closer and they would be touching. Good thought though. Thank you.
This is from a post by Redneck
“The range between max and min value need to be at least 100.
Make sure the sensor pressed firmly in the aluminium shaft. The magnet should be as close as possible to the sensor but not touching it.”2-3 mm seems a bit much, mine almost touch.
-
Hello,
The Vipergear close your operations, i have a cougar and need hal sensor to have a backup from my pots, someone have a outher option to buy a hal sensor to cougar?
Thanks
-
@djpich Are you sure you didn’t mix them up, they come in 3 sets , X Y Z - throttle if have.
They (vipergear) explained that they shouldn’t be mixed… eg. put magnet for X and hal sensor for Y.
Might be the case… , in newer revisions they had colored plastic cases… mine didn’t (older rev) but they came every set in separate plastic bag…Can’t hurt…