Markpoint created by FCR…How to change selection

[hreich]

I created 2 markpoint by fcr (26 and 27) but i dont know how to select each one as my active steerpoint…on hsd they are to small and im not sure if i can select them

Sent from my SM-A500FU using Tapatalk

[Planehazza]

@hreich:

I created 2 markpoint by fcr (26 and 27) but i dont know how to select each one as my active steerpoint…on hsd they are to small and im not sure if i can select them

Sent from my SM-A500FU using Tapatalk

Press 4 - STPT, then enter 26, followed by ENTR.

When you press TMS UP to create the markpoint, press 0 - MSEL to automatically set the just created markpoint as the active STPT.

[hreich]

Ok but if i first created 2 markpoints is siccesdion how do i select first and the second one?

Sent from my SM-A500FU using Tapatalk

[Agave_Blue]

You can save ?5 mark points. They are, in order, steerpoint 26, 27, 29, etc.

As mentioned, ICP 4 (steerpoint), enter 26 (or 27, or xx) and enter in the ICP.

Once you’ve saved the limit on markpoints, the ?6th one restarts at 26 and overwrites the original.

I’m sure this must be in either the -1 or -34 if you care to read/learn the details.

[lightswitch94]

-34 pg 25. 1.2.5 DED mark points

[Darkman]

@hreich:

Ok but if i first created 2 markpoints is siccesdion how do i select first and the second one?

The same way you select any steerpoint. See also -1 page 68.

Remember to reset any system delta you made by slewing your cursor (with Cursor Zero: see-34 page 142-), or your SPI will be your new markpoint + the previously created system delta.

[hreich]

Ok thanks to all replys…i am reading training tutorial, and avionics manual but didnt found it

Sent from my SM-A500FU using Tapatalk

[regev]

After you created the markpoints, choose the DED current steerpoint field (using ICP SEQ down) and change it to 26 as it is the first markpoint (or 27-30 for next markpoints). The mark point on the HSD will still be an X symbol but HUD will direct u to the markpoint.