Screen Resolution problem
-
Hi!
I’ve gota a problem with the resolution configuration. First my config:
- Two projectors projecting to a cylindrical screen connected to a RX480 graphics card (3840x1080)
- One touch screen connected to a R9 290X (1920x1080) for YAME and Helios
The problem is, I don’t know how I did it but I run falcon on 3840x1080 without a problem until it suddenly changed again to 1920x1080…
I went to the graphics configuration in Falcon and saw it had changed the graphic card to the R9 290X, I changed it back to the RX480 to change the resolution but the program crashed…
Since then Falcon starts in 2D, but when I go to the config or try instant action it crashes, so I can’t change config again and I can’t fly…
Is there any solution to modify the flacon config file externally or do I have to install Falcon again from the start?
Thanks. Regards
-
Did you try to delete the dx9display.dsp file in the config folder? BMS will create a new one after being started.
-
Did you try to delete the dx9display.dsp file in the config folder? BMS will create a new one after being started.
No, I’ll try when I get home. Didn’t know which file should I delete.
Thanks!!
-
in 4.32 (and older) it was display.dsp now it is dx9display.dsp it is responsible for keeping your graphics related settings…
-
Works perfectly, it now starts and the 3840x1080 resolution can be selected again.
Thanks!!!
-
[emoji106]
great you sorted it out, now maybe you like to share a picture of your screens/setup, it sounds really nice [emoji3]
