TQS switch value keeps changining with Tusba R2

[bstar07]

I use Tusba R2 and Cougar TQS.
I found out radar cursor is floating so that checked each of TQS switch value by HID Device tool.
My Cougar TQS microstick, AntElev and Uncage values keep increasing and back to normal.
I could handle microstick value by deadzone configuration. Seems to be no problem yet.
However, I wonder if this is normal. If it is not, should I change microstick, AntElev and Uncage parts?

[AV8R]

Not normal for good condition parts, but after they are used for a long time it might need more deadzone range.

Did you try the TM CCP calibration routine for the TQS knobs and cursor?
(Dont use the Windows control panel calibration method.)

Then use the TUSBA-R2 TQS calibration and deadzone setup.

Lastly, check operation within the BMS control setup pages

[bstar07]

@AV8R:

Not normal for good condition parts, but after they are used for a long time it might need more deadzone range.

Did you try the TM CCP calibration routine for the TQS knobs and cursor?
(Dont use the Windows control panel calibration method.)

Then use the TUSBA-R2 TQS calibration and deadzone setup.

Lastly, check operation within the BMS control setup pages

Hi! Thanks for your response. I thought everything would be fine, if I change trouble parts.
I just changed AntElev part. It works ok now but still have problem with Microstick and Uncage rotator.
I think I should follow your advice. But I wonder if TM CC calibration works cos my OS is Windows 10.

[bstar07]

Still have a cursor floating problem with the TM CCP calibration. I just set a wide dead zone by TUSBA-R2 TQS calibration tool.
Now it looks like the floating cursor issue is solved.