BMS ISSUES
-
Since I installed 4.33 I believe I correctly added u2 and u3, but sometimes my bms flight screws up and I crash as soon as the program loads on the runway.
-
Since I installed 4.33 I believe I correctly added u2 and u3, but sometimes my bms flight screws up and I crash as soon as the program loads on the runway.
Have you had a read of THIS THREAD??
-
thanks for that I don’t see any update 2 or 3 in my data folder but overtime I go thru the process above it states fully installed successful but nothing comes up in the data folder but u1
-
Look at the last image in post #5. If you have the same version number (Falcon BMS 4.33.3 (x86/x64) Build 16068), then you have Update 3 installed, otherwise, you may have missed something. Also look at the last image in post #2…. note that it shows Update 1, Update 2, and Update 3.
The easiest advice I could give is to start over and use my guide to help you with your install. Good luck!
-
Please also post the exact version of your operating system and PC specs?
-
Probably safer to choose taxi instead.
-
Know where your Install folder is.
And then direct each update to that same address.
Then run the 4.33 “setup.exe” installer again !
-
@Axe:
Probably safer to choose taxi instead.
LOL!!! I was confused there for a second…. “what does taking a taxi have anything to do with BMS???!!?”
:uham: -
https://www.dropbox.com/s/lbew3h6g5wf4mjt/IMG_2328.MOV?dl=0
what is wrong with it? As soon as I load the program either on the runway or carrier i don’t touch a thing and it does this?
