65f radar cursor drift

[Mower]

When using an axis or keystroke mapped the gate just keeps moving.

Thoughts?

[jhouse6352]

That was happening to me with the microstick on my Cougar. I adjusted the deadzone and curves to fix it.

[Blu3wolf]

Increase the deadzone in BMS.

Ive seen a few reports years ago about not using the windows calibration tool for the axis, as apparently its permanent? I cant recall it, I remember struggling with it for ages before applying the deadzone in BMS.

Problem solved (with the minor irritation that the stick has a deadzone, which I dislike). Problem was even more solved once I upgraded to a Cougar.

[johku]

@Mower:

When using an axis or keystroke mapped the gate just keeps moving.

Thoughts?

I had to increase the deadzone in BMS Advanced Control Settings to maximum. Then it stopped wandering around.

[drtbkj]

@Mower:

When using an axis or keystroke mapped the gate just keeps moving.

Thoughts?

Mower, I used to have this problem. I just jumped over and looked at my -65’s SST, and confirmed I did set the cursor via the BMS UI. I used the “DX” method
One thing you might try is to remap the keystrokes so they are not what I call combo keystrokes. For example, cursor right is “.”, not shift + arrow right. BTW,I did the same to the “critical controls” like TMS. I have had -65 problems in the past with combo keystrokes

[mantaray]

@Blu3wolf:

Ive seen a few reports years ago about not using the windows calibration tool for the axis, as apparently its permanent? I cant recall it,

Diview

[Mower]

@drtbkj:

Mower, I used to have this problem. I just jumped over and looked at my -65’s SST, and confirmed I did set the cursor via the BMS UI. I used the “DX” method
One thing you might try is to remap the keystrokes so they are not what I call combo keystrokes. For example, cursor right is “.”, not shift + arrow right. BTW,I did the same to the “critical controls” like TMS. I have had -65 problems in the past with combo keystrokes

This worked. Thanks.

[drtbkj]

@Mower:

This worked. Thanks.

You’re welcome, glad it worked