Virpil CM3 axis inverted,,cant seem to fix
-
Re: Virpil CM3 Throttle inverted axis
For some reason my virpil CM3 axis got is backwards, in that when the throttle is at 0, BMS throttle is at 100 % and when the throttle is at 100, the BMS throttle shows 0%,
I opened the configuration software and clicked on the Inversion button and saved. I had to recalibrate but now although the virpil configuration software shows the input source going from 0 to 100%, the Axis logical (output) only hovers between 49 and 51%.
I tried checking the setting the inversion for rY and not checking the inversion for rX, This shows that inversion is false for rX and true for rY, but BMS still has the setting reversed.
If I check both settings to inversion, then both inversion shows true and the axis output is between 49 and 50%,
Any help with this,I am using 4.35 as I have a number of training missions and don’t think they are compatible with 4.36.
Any help would be appreciated,
-
@jack72 The BMS device setup guide is in the HOTAS folder C:/FalconBMS4.36/HOTAS
-
@jack72 said in Virpil CM3 axis inverted,cant seem to fix:
help with this,I am using 4.35 as I have a number
Pretty sure support for reversible throttle-axis was added in 4.36.
I think the checkbox was always there, in the Setup page UI, it just didn’t do anything before… iirc.
ps it’s a little unintuitive in 4.36, but you have to re-assign your AB and Idle-detent positions, after toggling the axis reverse.
https://forum.falcon-bms.com/topic/22780/throttle-reverse-checkbox-not-working-as-expected