Have to reset/calibrate all my axisses and knobs whenever I go out of pit
-
-
@airtex2019 not the throttle.
I have a full pit and some radio axes are reversed and also I need to add sone dead zone to my rudder pedals… -
Sorry, my mistake.
I found everything. -
-
@airtex2019 said in Have to reset/calibrate all my axisses and knobs whenever I go out of pit:
No. Throttle axes are normal, but everytime before I can go in pit, I have to do the following :
- set AB and Idle positions
- set the deadzone for my rudder
- set the deadzones for both X- and Y-microcursor.
- Reset both axes for my microcursor (they have been switched )
- X-axis for X-microcursor has to be checked “reversed”
-
@Doc0301 do you use the launcher?
Are you resetting all this stuff in sim and not in the launcher?
Any changes you make in-sim will not be saved if you use the launcher, as the launcher overwrites the key file with its own one on every launch.
-
@SOBO-87 In UI. I understand, but after a lot of trouble getting my BMS working on my new PC and Win11 (A LOT of trouble!) I 'm glad I got it working at all. Was just wondering if there was a way to avoid this little dance without FUBAR my setup
-
@Doc0301 ok so you don’t use the launcher at all?
-
@Doc0301 if things are still borken with 4.37.1 + Alt Launcher 2.3 … can you post a screenshot of your AXISASSIGN page?
I’m assuming you’re using the new/alt launcher… wasn’t clear.
-
@SOBO-87 That’s just it! I set all my keybinds with the Alt, but BMS didn’t find my TUSBA throttle axis. After a week of searching it suddenly worked and now I’m afraid of changing anything. Did I mention I’m a computer zero
-
@Doc0301 when you said BMS didn’t find your TUSBA axis? Did it show up in the launcher? But didn’t work in sim?
-
@SOBO-87 BMS did see my TUSBA throttle , but I only had 40% of the full range. FYI It works fine now. The problem described above remains, but I can live with it
-
@Doc0301 have you tried resetting the things you reset in the launcher rather than in sim UI?