CH Pro Throttle DIY detent
-
Right…?
Genius bit of engineering.
PS. I showed a (hot little) chick YOUR detent device the other day.
She thought it was genius…!!
Dude, you (as I said to her) were so sweet to make all of those photographs and animated .gif and stuff, man. I didn’t get it at all, and then you went to all that effort. Then even Dunce-Gorn totally understood.
I really appreciate it, man.
What a lovely and kind fellow you must be.
Ara’
-
@Aragorn No worries. I get also my first explanation was too simplistic.
Also, I’m glad I can return to the community some of what is being given to me
-
I know this thread is old but I just came across it and thought I’d share my own detent design that I made for my CH throttle a while back. I had two main goals:
- No permanent modifications required/100% removable
- Minimal travel loss while crossing the detent
I think I was able to pull both of these goals off quite well with the design I came up with. All parts just snap together around the throttle and can be glued for greater security if desired. Additionally, by adding a collar around the throttle arm I was able to make the detent bumps much smaller than would be required otherwise, reducing the travel crossing the detent to just ~8% of total travel.
Files available here:
https://www.printables.com/model/233393-ch-products-pro-throttle-detent -
@Spock Clever design!!!