About Port mapping

[Vespa]

Hello all, hope you’re fine !
i got a question about how to host on BMS. I would like to host with 2 computers (not in same time for sure) without to change any time my IP Adress on the Portmapping setup page .
On my internet-box page i can only add 1 IP for Internal Host, i’don’t know if we can use the REMOTE HOST for a second machine…

Any ideas ?

[airtex2019]

@Vespa when people send packets to your home ip address, your router needs to know which one of your PCs to forward the packet to

it can only be one… this is what port-forwarding means

[Vespa]

@airtex2019 oookay ! I understand. Thank you.
Dors Falcon BMS IPv6 ?

[airtex2019]

@Vespa I think so but I haven’t tried IP6.

I think a lot depends on your ISP… and router

[Fish44]

@Vespa
I think you would need to change the default ports for BMS on one of the machines, and forward these ports in your router. So you would have a different port range for each of your machines. You can’t forward the same ports twice (i.e. for the two hosts).

There is an option in the config set g_nServerPort, but i have never tried it.