Jammer XMIT selection
-
I cannot find anywhere, in the manual or the key listing, where the selection of the jammer XMIT mode is. I would expect a toggle button to run through the 3 XMIT modes, or a button for each of the 3 modes. Advice please.
-
@jagfour I think there is no keybind by default and you have to use the switch on the ECM panel. Not 100% sure though…
-
-
@Master-Yoda Yeah I have seen that. Can you imagine fumbling about down there with a Mig on your tail.
I have been made aware of this new ECR by a yt vid that shows you what all the buttons do. I have thought that there should be 2 new lights, triangular in shape, either side of the jammer light. The left light on for XMIT 1. Both lights on for XMIT 2 and both lights flashing for XMIT 3. -
@Master-Yoda Which keymap is that. Its not in the F-16 default map?
-
@jagfour It is check the BMS Full.key file.
You might not have as you probably kept a BMS Auto.key file across an update that introduced the new callbacks.
If an update introduces new callbacks you either have to merge them manually from the BMS Full.key to your BMS Auto.key or let the Launcher generated a the BMS Auto.key file newly from the BMS Full.key file by deleting BMS Auto.key file and restarting the launcher (takes the updated Full.key and cpies it with the new callbacks to Auto,key)As well documented in Technical manual:
-
I have successfully c&p the missing entries into my own keyfile. Thanks for help.
-
This post is deleted! -
@jagfour said in Jammer XMIT selection:
@Master-Yoda Yeah I have seen that. Can you imagine fumbling about down there with a Mig on your tail.
I have been made aware of this new ECR by a yt vid that shows you what all the buttons do. I have thought that there should be 2 new lights, triangular in shape, either side of the jammer light. The left light on for XMIT 1. Both lights on for XMIT 2 and both lights flashing for XMIT 3.if the MIG is close on your tail i doubt ECM will save you anyhow
