Cursor Depress + Cursor Movement Issues
-
Hey all.
My TM Cougar TQS has one of the Deltasim force sensor upgrades for the cursor control. This works great and I already use a deadzone on it. But due to the design of switch it seems impossible to actuate the “depress” function without also inadvertantly putting in some X or Y command on the cursor as well.
When I’m in dogfight mode and I’m depressing cursor to swap between slave/bore the cursor movement also puts the radar into slewable mode, I get the cross up in the middle of the hud with the numbers showing where I’ve slewed the radar to.
Is there any way in BMS already that I can disable the cursor X and Y movement whenever the cursor depress is enabled?
-
that’s a tough question man. I’m sorry I don’t have an answer, but I may be needing an Deltasim Force Sensor upgrade myself for my Cougar. Are they still around?
-
@SOBO-87 you maxed out the deadzone for x and y?
-
@16th-ACCW-Android Yep Damien is still producing stuff. I have loads of his products and I highly recommend all of them.
https://deltasimelectronics.com if you need to order something.
-
@airtex2019 said in Cursor Depress + Cursor Movement Issues:
@SOBO-87 you maxed out the deadzone for x and y?
Yep! It’s due to the force required to depress the cursor, if you’re not very careful you invariably add some x or y movement.
It would be so nice to have a config option that when the cursor is depressed it ignores all X and Y inputs. But I’m guessing that doesn’t exist.
