Increase saturation
-
Hey, I bought an awesome tianhang stick that can take a fair bit of tugging to break. It’s got a rumbler that activates at 100 percent axis range. It’s nice to have to protext the stick, however its irritating to have rumbling all the time in say a scissors.
In DCS i canset my X saturation to say 50 percent which means I can slacken off when I feel the rumbler but still perform a max turn. In BMS however the max saturation amount is LARGE and that only give 10 percent which is too small of an amount for me to find that magic zone between full axis deflection and rumble. Is there any way to increase this or can I request it be added in the future if its easy?
-
@Swoopy said in Increase saturation:
Hey, I bought an awesome tianhang stick that can take a fair bit of tugging to break. It’s got a rumbler that activates at 100 percent axis range. It’s nice to have to protext the stick, however its irritating to have rumbling all the time in say a scissors.
In DCS i canset my X saturation to say 50 percent which means I can slacken off when I feel the rumbler but still perform a max turn. In BMS however the max saturation amount is LARGE and that only give 10 percent which is too small of an amount for me to find that magic zone between full axis deflection and rumble. Is there any way to increase this or can I request it be added in the future if its easy?
It is strongly recommended that you fly with the default profile that comes with the FALCON BMS because that’s how the flight modeling gurus designed it, whether using a joystick with a mechanical gimbal or a pressure sensor (transducer). They designed it this way so that the stick movement behaves just like the actual aircraft’s stick and its behavior.
However… if you want to configure it even beyond the recommendation, you can do so using AL.
-
@Swoopy said in Increase saturation:
In BMS however the max saturation amount is LARGE and that only give 10
I think the OP is well aware of setting saturation in BMS itself, I think no need to point him to that.
@Swoopy I don’t know about the tianhang firmware/software as I use a WW Force sensing, but I could set setup what you want to achive on the Stick software itself instead of having to rely on a game saturation.
If realy needed you might achive setting up a cusom saturation by mapping a JoystickGremlin curve -
@Swoopy you can define custom saturation via the g_nAxisSat* cfg params
The value is a percentage, 0 to … I think 50 is the max? not sure without looking at code
