Saitek X55 Throttle Inverted/Reversed

[senor-taco]

Hello all, just bought the x55 and come to find out the throttle is picked up in BMS as 100% rather than 0% when brought all the way back. Does anyone have a solution or a code to put in a config file?

Thanks!

[Agave_Blue]

In BMS Setup, can’t you just check the ‘reverse’ box for the axis? (Assuming there is one for the throttle …. ?)

[senor-taco]

Unable to do that with the Joystick as the main controller…

[Malc]

Can’t you reverse the axis in the Saitek software?

[Frederf]

@senor-taco:

Unable to do that with the Joystick as the main controller…

Yes you can, go into the ADVANCED section.

[cns180784]

@senor-taco:

Hello all, just bought the x55 and come to find out the throttle is picked up in BMS as 100% rather than 0% when brought all the way back. Does anyone have a solution or a code to put in a config file?

Thanks!

So on the setup page where you have the throttle gauge, when your throttle is set all the way back (idle) is that gauge fully blue? coz i noticed when i assigned my throttle axis in the advanced section, (x axis for throttle) the bar for that was fully blue when it was all the way back, but the throttle gauge on the main setup page was clear so i knew it was set right, just wanted to make sure you mean the throttle gauge on the main setup page and not in the advanced section.

[senor-taco]

I fixed it this morning, in the madcatz software! You’ve got to change the curve profile of the throttle. In BMS it detects a positive slope, as the controller is naturally set to a negative slope…awfully weird.

-adios