BMS 4.33 Radar Elevation problem and graphics glitch
-
Hi Guys,
I (and my mate) are having the same problem with radar elevation in BMS 4.33
At 40nm range, the elevation limits are showing as -99 -98.
Only when you set range down to 5nm can you get the radar to scan above ground level!
We cannot get the elevation to change or reset to center. We are currently using the old 4.32 keystrokes file as we are having trouble with the new key mapping (radar slewing continuously and other bindings not functioning properly), so F6 should center the radar, but it doesn’t.
Another issue we had was that target buildings did not appear on a DEAD mission, and runway textures and buildings where gone on RTB, using 500 as the bandwidth.
any suggestions?
-
My bet that radar elevation is automatically assigned one of rotator on your joystic. I experienced the same, even moving radar cursor was impossible. Check the controls and advanced settings part.
-
THANKS!!
Its even more annoying when the answer is simple.
That was it. Going to up the bandwidth to try and solve the other issue.
-
We are currently using the old 4.32 keystrokes
Don’t.
You should be able to make the new 433.key working properly. Otherwise, adapt you HOTAS profile accordingly.
It is a little bit painful, I know, but this is HIGHLY recommended. No way to guaranty anything by using your old 432.key for the new avioncs features.