Hotas warthog keyfile
b.s. last edited by
So i’ve sat down with the gui and mapped out every single button on my hotas warthog stick, throttle, and L and R MFD switches.
All’s well, I can see a DX mapping for every single button, in sequence that I can find to push…
Except for a few…
The buttons on the yok stick are all accounted for, 1-19 (except for the pov hat).
This leaves 20-32 as ??? They are recognized buttons, but I don’t think I have an actual buttons to push for these…
Then the next button that appears is 33 on the throttle stick.
Every button on the throttle is sequential through 64.
The L_MFD is sequential 65-92.
There is then a break of 93-96 that are ???
And the R_MFD is sequential 97-124.
So my question is,
For DX 20-32, and 93-96…
Where are the buttons for these mappings, that I apparrently can’t push??
I suspect they are maybe internal to the devices (?)
Or maybe I am just dumb and don’t know how to find, like 17 missing buttons that are right in front of me???
I suspect that some of them might be set to the stick POV.
I (of course) can not recognize my throttle coolie POV (standard, but unfortunate)
On the other hand, I can push almost all of the buttons that I can find to put my fingers on… So what’s the big deal (?)
I’ll probably take the HOTAS COUGAR section from the BMS - Full.key and morph it to HOTAS WARTHOG, and see if that works well enough.
Haven’t gotten into shifted layer yet… Nor making the 3 way switches actually register all 3 settings (for example, the AP 3 way switch is forward (59) path , middle (no dx setting) alt/hdg , and aft (60) alt. I wish to figure out how to recognize all three of these positions, instead of just 2… ideally without using TARGET (probably out of luck, there)
Any thoughts or feedback appreciated,