Hotas warthog keyfile
-
Greetings,
So i’ve sat down with the gui and mapped out every single button on my hotas warthog stick, throttle, and L and R MFD switches.
All’s well, I can see a DX mapping for every single button, in sequence that I can find to push…
Except for a few…The buttons on the yok stick are all accounted for, 1-19 (except for the pov hat).
This leaves 20-32 as ??? They are recognized buttons, but I don’t think I have an actual buttons to push for these…
Then the next button that appears is 33 on the throttle stick.
Every button on the throttle is sequential through 64.The L_MFD is sequential 65-92.
There is then a break of 93-96 that are ???
And the R_MFD is sequential 97-124.
So my question is,
For DX 20-32, and 93-96…
Where are the buttons for these mappings, that I apparrently can’t push??
I suspect they are maybe internal to the devices (?)
Or maybe I am just dumb and don’t know how to find, like 17 missing buttons that are right in front of me???I suspect that some of them might be set to the stick POV.
I (of course) can not recognize my throttle coolie POV (standard, but unfortunate)On the other hand, I can push almost all of the buttons that I can find to put my fingers on… So what’s the big deal (?)
I’ll probably take the HOTAS COUGAR section from the BMS - Full.key and morph it to HOTAS WARTHOG, and see if that works well enough.
Haven’t gotten into shifted layer yet… Nor making the 3 way switches actually register all 3 settings (for example, the AP 3 way switch is forward (59) path , middle (no dx setting) alt/hdg , and aft (60) alt. I wish to figure out how to recognize all three of these positions, instead of just 2… ideally without using TARGET (probably out of luck, there)
Any thoughts or feedback appreciated,
Thanks yall