Strange behaviour in AG mode regarding SOI
-
Rather than try to explain it all, here is a short video:
Following the procedure…
- Switch to AG mode
- DMS down toggles SOI between AG radar and HAD
- Enable AG radar Snowplow mode
- DMS down toggles HAD as SOI on or off. No SOI frame appears on AG radar, moving cursor doesn’t work.
- TMS up while no SOI brings the frame up
- Normal SOI selection can now take place
Is this normal behaviour?
-
Ground stabalisation (setting of SPI) in SP mode required for SOI maybe?
i RTFM’ed
Page 128 in the -34
“The cursors remain at this range while the ground map video moves, or “snowplows,” across the MFD. At this point, there is no SOI, and the cursors cannot be slewed.”
-
Ground stabalisation (setting of SPI) in SP mode required for SOI maybe?
i RTFM’ed
Page 128 in the -34
“The cursors remain at this range while the ground map video moves, or “snowplows,” across the MFD. At this point, there is no SOI, and the cursors cannot be slewed.”
Heh, you beat me to it. I just looked at the same page in the manual. Mystery solved…
Almost embarrassed, I might need to bribe a mod into deleting this thread now…
