Cannot turn on TGP

[soldano]

While flying the inflight versión of the training LGB missión, I can select the TGP but cannot turn it on, as it remains in standby mode.- I have already enabled master arm and laser arm, selected AG master mode, configured the UFC Laser page as per the instructions, etc .- What am I forgetting ?
Thanks

[Agave_Blue]

Is your hardpoint power on? HUD switch panel, top row …. two switches on the left (left and right hardpoints).

[soldano]

Yes, both switches are on

[Blu3wolf]

If hardpoint power is not on, you would not be able to get the TGP into standby mode. You do not need to enable master arm or laser arm to get the TGP out of standby, and it is functional in all master modes. The laser page is only required to adjust the laser code and is also not required to set the TGP out of standby.

So, does the TGP display NOT TIMED OUT in the middle of the MFD while you are trying to get it out of standby? If so, you need only wait for the TGP gyros to spin up (this will take a few minutes).

[soldano]

No, it only displays standby and it remains that way

[Frederf]

You have to select an operating mode. Press the OSB next to the label STBY and then the OSB next to AA or AG.

[soldano]

@Frederf:

You have to select an operating mode. Press the OSB next to the label STBY and then the OSB next to AA or AG.

That did it, thanks