Button config keeps changing
-
Hi everyone,
It doesn’t happen all the time but too much to my liking. I start up bms and have all the buttons configured correctly. In 3D everything works fine, no problemo. But sometimes, when I end the mission and want to do another, more then often my configuration has changed although I didn’t do it. It’s always the micro-stick and the range-button, it changes into rudder. If I set it up correctly again it all works but it’s frustrating. I did save the file and hit the apply button but no luck. If I reconnect my arduino-panel it’s a sure thing it goes off. But again, even if I don’t change anything it still does things I don’t want it to do. Known issue?
-
BMS-Manual (in your \Falcon BMS 4.33 U1\Docs\Falcon BMS Manuals folder) pages 49-50 might be worth reading.
I don’t think BMS is causing it, it sounds like a DirectX issue, but hopefully you’ll understand how to prevent any permanent changes to your config when you read that section.