Canopy switch : three positions. The down position is momentary. The up pos is steady. The middle position is the stop position. The reason of momentary is that when closing the canopy there could be crewchief or material between the canopy and the sill. Releasing the switch stops immediatly the closing process. Hold the switch down until the canopy is locked. It,s now perfect programmed in BMS !!
Latest posts made by JJO
-
RE: The 3-position canopy switch
-
RE: Key presses
I had the same problem with one switch. I realy could not find the problem. Its now solved. I started BMS, clicked on setup and controller and just waited. On a complete random timeset my FLT CNTRL BIT switch activated without any reason. After replacing all problems were gone.
-
RE: 4.35 UHF Radio Keys Switch screen settings
Super, looking forward to the update.
-
4.35 UHF Radio Keys Switch screen settings
Maybe it’s already know by the development team, but i can’t find any info on the forum. All the keys wich have ALT+Enter, switches the screen settings, it means that when i switch on my backup UHF Panel, the screen changes to full screen or windowd. For your info, i have a full cockpit with an UHF panel electronics developed by Wolfman. Because the keys are hardcoded inside the panel, i can’t change the keystrokes. I did that with the DL switch to avoid the screen switching.
is there an update coming for this issue?
regards
JJ -
RE: X65F 3d print Physical Lift Detent
You have to lift the throttle to move it to the AB position.
-
RE: Central Europe Theater
+1 i could fly over my house thats at the end of the airstrip of Twenthe…falcas, any possibilty it will be available soon?
-
RE: The jsf start switch
Thanks for your help. I realy need to start learning the manual of the F16…
JSF switch works perfect. What did i do on your advise.
1. i activated the cutoff/Idle on the throttle
2. throttle calibration
3. Power to forward position
4. Fuel to norm
5. Hold the jsf several seconds until the green indicator lightens up.
6. After 20 pct , move the throttle to idleup to the next cable to make ( gear panel)
-
RE: The jsf start switch
thx, i will do some tests this evening. What i did see is that the switch isn’t moving at all in 3d cockpit, while the keyfile is ok because the configuration settings inside BMS works. What you write about the throttle is the same what i saw… so work and test for me to do…
Extra info, i have a full cockpit interfaced with XKEYS (Switches) / AIC (Indicators) / Pegasus hardware and software (EHSI, DED and PFLD) and PHCC (instruments)
-
RE: The jsf start switch
thx, i will try this evening again. i pushed the switch indeed many times, maybe i missed the start….
-
RE: The jsf start switch
Same problem here, i modified nothing. When i test the switch in configuration, it’s ok. But when i want to do a ramp start, the Jetstart switch does nothing. Not with the hardware switch, not with the keyboard and not with the mouse. I will check if there is a conflict inside the keyfile, but i am worried about this. My main question : why is it working inside BMS/ config setup and not when i want to do a ramp start.