I finally figured it out, you just have to keep hitting Shift-K until it clears that screen. Startup worked just as you said…Thanks a ton!
Latest posts made by atrdriver
-
RE: Morphine's Profile
-
RE: Morphine's Profile
Yes, that’s how it is working on mine as well, but in that first training flight for some reason it either isn’t seeing the throttle moving to full AB or to full OFF, I’m not sure which. And in that tutorial there is no way to get by that step unless it sees both full AB and full off. When I’m in the controllers setup screen I see that lifting the throttle over the idle detent sends an ALT-i. This one is driving me crazy. I will try posting in the tech support and see if anyone there has any ideas. But when I’m flying I can shut down the engine by pulling the throttle over the idle detent…
-
RE: Morphine's Profile
Thanks Morphine, I will try the TMS up. I know the button is working. However, another question. I decided to go through each tutorial from beginning to end because I want to learn to fly this thing right. In the first tutorial, Ramp Start, I keep getting stuck on the throttle initialization. I am obviously using your profile and key file, and I have the idle detent redline setup up slightly above the bottom the the throttle movement (although I have tried it at the bottom as well). I have also enabled the idle cutoff patch in the config. But the tutorial says to move the throttle from idle to full AB and back to off, and for some reason it thinks I am not either moving it to full AB or to off, not sure which. I have the AB green line set in the dead zone. In the setup when I move the throttle over the detent to off it shows a key combo of Alt-i. I really don’t want to get stuck this early…:) Any ideas?
atrdriver
-
RE: Morphine's Profile
I hate to ask what is probably a really dumb question, but I can’t figure this out. I can use the RWS or TWS mode without problem, but I can’t designate a target. I have tried TMS right but that seems to only change the presentation of the FCS screen. Whenever I use TMS up or down they won’t be designated. I have gotten it to work once, but I don’t really know what I did to make it work.