Hi, I have a Warthog and I found a profile and TARGET cannot be used to load a profile, you load it using the Script Loader. Once loaded you can go into BMS and setup your controls. It’s been a while however I believe the rudder has to be reversed. I was using this with BMS 4.32 update 6 with a virtual squadron. I went back to school for my medic cert and due to the amount of homework took a leave. I also had the Track IR5 with the pro clip. The warthog for me worked much smoother then the Saitek X65 which I tried for 4 months and no matter what I set it at could not control the jet well enough to air refuel, others had no issues with it. In summary there are good profiles for the Warthog out there and having two throttles with stops at idle and AB plus it’s built like a tank. i bolted my throttle down, with this we are good to go with twin engine fighters. As stated earlier I had to load the profile using the script launcher that comes with the software.

Hi, One more question, before when trying to lock a ground target I would push TMS Up once and it would ground stabilize, how do I perform that task now, as that no longer works.
Thanks
Ron

I used to be able to go into setup / control and use the keystroke page to match all the OBD buttons 1-20 on each MFD and I had several ICS functions on the rockers including HUD Color and HSI coarse and heading changes. In fact I am thinking of buying two more MFD’s if BMS will support them as a lot of functions could be placed on them. I just highlight the keystroke area and press the button on the MFD and its done. When I said used to be able to it changed when I used TARGET and I think I will have all the functions back again today. One note is TARGET sees MFD #1 as the Right MFD and 2 is the Left.

Ron

I am going to try this out today and if it works your my hero. Please read all my recent post’s and replies. As I have been fighting this for weeks. I am assuming I will have wheel brakes, TMS and cursor functions as well. Can you give me advice on the throttle and stick settings as I stated please read my posts and I will be waiting for your replies as you may of saved me a lot of grief.

Thanks. Ron