Thanks for all the replies! I was the host in this instance, and my BW was 1024.
We will try everything listed here and hopefully solve the issue!
Good to see a community that is so quick to help each other out!
Thanks for all the replies! I was the host in this instance, and my BW was 1024.
We will try everything listed here and hopefully solve the issue!
Good to see a community that is so quick to help each other out!
THANKS!!
Its even more annoying when the answer is simple.
That was it. Going to up the bandwidth to try and solve the other issue.
Hi Guys,
I (and my mate) are having the same problem with radar elevation in BMS 4.33
At 40nm range, the elevation limits are showing as -99 -98.
Only when you set range down to 5nm can you get the radar to scan above ground level!
We cannot get the elevation to change or reset to center. We are currently using the old 4.32 keystrokes file as we are having trouble with the new key mapping (radar slewing continuously and other bindings not functioning properly), so F6 should center the radar, but it doesn’t.
Another issue we had was that target buildings did not appear on a DEAD mission, and runway textures and buildings where gone on RTB, using 500 as the bandwidth.
any suggestions?