Are you using OSB 4 OVRD (temporarily turns off radar) at all? Leaving that on while switching master modes causes similar issues for me.
Latest posts made by Mar
-
RE: Hands on switching between ACM/CRM ?.
-
RE: Help with setting up comms
There’s a whole new comms structure since 4.34. Check out the new manual “BMS-Comms-Nav-Book.pdf” in the Falcon BMS 4.34\Docs folder.
-
RE: Master Caution/Elect systm/EPU
Yep, you’re not supposed to pull the pin before engine start. It’s an excellent way to send the ground crew to the hospital.
Then again, maybe they don’t have insurance and need an excuse. Case by case basis.
-
RE: Mode 3 IFF
In other words, the F-16’s interrogator will not show you what code the other plane is broadcasting, it will only tell you whether or not it matches the code you’re scanning for.
-
RE: Hi
Hi Jeepee, welcome to Falcon BMS!
First of all, I would encourage you to check out the Alternative Launcher, it tends to make assigning controls a bit easier: https://www.benchmarksims.org/forum/showthread.php?31774-Falcon-BMS-Alternative-Launcher-(Easy-Setup-Keep-Joystick-Assignments)
As for your issue, I’m not sure what could be making this difficult. You have the throttles separated and are only moving the right one all the way up and down so that it will be detected as the one you want to assign, is this correct?
-
RE: Arrester Cable
I guess you think that comment witty and funny? Don’t give up the day job…
No I’m serious. I’ll hijack a brewery if it’ll help you wind down.
-
RE: Arrester Cable
Well, I thought it was…
Malc, I don’t drink, but I could hold up a liquor store if you really need it that bad…
-
RE: Arrester Cable
Guys, the solution is simple.
Put a carrier under the runway.
Glad to see the language barrier has been overcome in this thread.
-
RE: How to use weather maps auto update
I’m so stupid. It is working, the transitions are taking longer than I thought they would. Sorry about that.
Still don’t understand that +1 minute tip though, but I can deal without it.
-
RE: How to use weather maps auto update
Now I just did the same as previous post again except I renamed the inclement map to 11400.fmap. It never changes from sunny.
I guess it’s broken.