@Minrah:
the HOTAS i have is a Saitek X52, now I tested the Idle cut off option both on and off in the config option on start up of falcon. the odd thing is that when I have it enabled the FTIT goes over 800 degrees with out me giving any gas when the sec light goes out.
This is because you do not have the throttle configured properly for idle cutoff enabled. This is the option I use with my Warthog setup and it behaves identically as it did in 4.33.
@Minrah:
when I have the idle cutoff disabled, it stays at 20 idle power like it should and doesnt over heat but I no action of my throttle even when i set the idle. I followed and read the 3.5.3 HOT START section of the new Manuel and im not ruling out that ive done something wrong.
It should get up to 25% before it stops. You either aren’t triggering the idle detent or your throttle isn’t configured properly for the second case.