Exactly. Set lower cursor speed and increase your dead zone on both cursor axis.
wilco, Thank you!
How do i exit slewable once im in it? say go back to NO RAD?
Exactly. Set lower cursor speed and increase your dead zone on both cursor axis.
wilco, Thank you!
How do i exit slewable once im in it? say go back to NO RAD?
so that happens because i TMS up while my cursor moves in DGFT mode? the cursors do drift sometimes now that i think about it…
Hey guys, im using the thrustmaster cougar HOTAS.
When in dogfight mode, i try to TMS up in order to get the radar slaved to the HMCS, but instead i sometimes get slewable mode.
Is there a way to fix this?
hey guys,
my friction pad disintegrated in my tqs, and i want to print a new one since TM dont sell those anymore.
looked everywhere for its dimensions with no success.
does anyone have one lying around to measure?
thanks, Nitzan
that did the trick! thank you.
Nitzan
Agave_Blue - can you elaborate?
i havent changed anything during install.
Nitzan
hey guys,
after installing 4.33u3 i noticed that the dgft/mrm cancel function isnt working on DUNC_DX.
is anyone else getting this?
thanks,
Nitzan
ok, problem solved!
it turned out to be the metal tab with two screws that holds the connector on the base - someone over-tightened those, which made the connector too low. hand tested everything works fine!
all i had to do was to put two washers for it to be a little higher up.
seems to be working great now
nitzan
red dog, thanks for your reply,
the problem is the buttons dont register, so depressing the triger does nothing.
my question is - could ths be a software failure, and if not - where should i look in the hardware?
nitzan
hey guys, cougar newbie here:
got my cougar, followed cub’s guide, everything seems to be in order, when i opened ccp - it said i have to update firmware. i ran cougar update, got nothing.
when i opened the control panel to see whats wrong - i saw that none of the stick buttons worked. axis are fine, throttle buttons all work ( no indication of cursor though).
i checked the grip connection - everything looks o.k.
help
nitzan