@Agave_Blue:
OK, so this problem exists 1.) with your keyfile using SST and 2.) with my DX profile (which has VERY limited commands in Saitek SST)?
Do you have other devices connected …. rudders, MFD’s, etc?
In the Saitek Control Panel, check the following: MFD Page, Lower right, “Enable Clutch Mode” is NOT checked.
Are you running Teamspeak when this occurs?
What Saitek/X52 driver version are you using?
Agave_Blue, all settings are correct and TS isn’t running (I’m aware of the porblems with TS too). Maybe I explained myself wrong, but there’s no problem with your DX profile, the problem is withing the SST software. I can’t move the radar cursor with the mouse
axis of the HOTAS. I’ve changes the key asignation to the keboard arrows just to check if it would work, but it simply does nothing.
By the way, I’ve the latest drivers and software version, and I’ve also installed previous versions with the same result.
@Adamski_NZ:
It looks to me like BMS is simply ignoring the “UP” state of any command set by the SST software. Everything just auto-repeats - even if I program in additional “up” key presses in a macro.
Adamski_NZ, maybe your problem is caused by ‘Direct Output’ process. Just go to the Windows Task Manager and kill the process. Give this a try, because I’ve got the same problem using TeamSpeak while flying, it’s a known issue.
Regards,