So did the A/A training missions and manual get updated yet or did it turn into 4-5 falcon years?
Latest posts made by ShepT
-
RE: AA training missions
-
RE: Begging for help, ready to give up.
i can send you my config file if you would like. Then all you need to do is import it in to the BMS Key File Editor then export back user/config folder. The only thing you should need to do is make sure the fighter stick is controller1 & Throttle is controller 2 in the DX Settings tap. They both will be primary input devices. My profile would includes trackIR recenter. PM me your email if you want me to send it…
-
RE: Begging for help, ready to give up.
.
I have my 3x 1080p displays setup in nvidia surround with bezel correction. Thats about where all the good new ends.
I can’t seem to get my controls to work. I have a CH Fighterstick and Pro Throttle. Yes its running in mapped mode. Yes I have saved and applied the profile.
I run with 3 monitors just like you, works great…you just need the horse power to support all three.
As far as setting up the controller, I have the same CH products and CH paddles, they work great with BMS with the Key File Editor. Do yourself a solid favor and use the included Key File Editor, learn it and you will be very thankful once you do. Its not really that hard to figure out if you stick your nose in it. Good luck!
-
RE: MAVs
Actually, no. Check out p.148 of the -34.
- if Mav in Pre, can do a TGP handoff, or FCR, whichever is SOI
- I don’t believe TGP would handoff in VIS, but you wouldn’t need to. VIS is like BORE, but with a slewable LOS via the wpn page.
So in VIS no boresighting or handoff is required then.
-
MAVs
Can someone tell if this sounds about right.
In PRE mode handoff can only be achieved with FCR lock? The missile is slaved to the FCR. Boresighting is required?
In VIS mode handoff can only be achieved with TGP lock? The missile is slaved to the TGP. Boresighting is not required or is it?
In BORE there is no handoff since the missile is used to lock and guide itself to target.
What strategic value or purpose does PRE give you over the other modes. Maybe bad weather or get in quick and get out quick because of heavy defenses…
-
TEs - setting up extra time on target?
How do you create loitering time at a target/steer-point. i am creating my own training missions so I can have max control over parameters. For example I want to take 10min or so doing AGM work at target but ultimately fail the mission/s due to timing. What is the best way to set this up? Thanks…
-
RE: TE KaesongStrike Loadout
@jc1:
I’m still using 4.33 not u1. I converted KaesongStrike with MC v4.9.189 but it still CTD with 4.33. Did it work for you with 4.33?
No i did not covert it over for 4.33 just 4.33U1 but I dont think that should matter. Are you sure you converted it correctly? Make sure you have all the directories sorted out correctly.
-
RE: TE KaesongStrike Loadout
You have to use mission commander to convert it to 4.33 U1. I converted it and it works fine. It did the same thing to me at the load-out screen before i converted it. Works fine after conversion.
-
Can VAC emulate real radio use protocol?
I was thinking of setting up VAC for radio calls but I have not found a good guide or an answer a important question that will make it or break it for me. Is there a way to make voice commands dependent on using the mic with proper band/channel/frequency…instead of a generic open mic situation. If so can someone point me to a guide or somewhere I can read more about how to set up this type of configuration.