@airtex2019

I just changed the graphics to borderless, but when I run BMS it starts and stays in a smaller window. Is there a way to keep the borderless setting but have it go full screen upon start up?

@airtex2019
Thank you

@Paulg-0

Thank you

I have a new Win 11 desktop with a GeForce RTX 3060 graphics card.

I just installed 4.36. Have not played in awhile. In set up I see my graphics card listed and I have changed my resolution to 1920x1080. I notice however the category listed as Output file has only the 1 setting and it is \.\Display9 1024x768 0 0 1024 768

I launched a quick play and it seems to me that the resolution is not as crisp as I remember it being. Is the output setting overriding the resolution I put in? I’m not sure what it means frankly, nor how I would change it anyways.

can someone give an idea of how this works as compared to the resolution setting?

thank you for any assistance you can offer.

Question about Issue related to Mission Commander:

Playing the campaign of Double Dragon
Have BMS Falcon 4.34u4 in stalled
Using MC 0.5.13.522
In the BMS 2D map I have bridge named “P’arwon-ni” that shows up in color and status as being owned by ROK. I go into MC, load the appropriate campaign file and this bridge has an entirely different name of “T’aech-on” and shows being owned by the PRC. In fact using the find feature there is no bridge named “P’arwon-ni”, although there is a town/city with that name.

Am I doing something wrong as I cannot figure it out. Thank you for any assistance you can offer.

A fully functioning F-16 updated with all the most recent features, filled with b1 tank of gas, and loaded with 2 AIM-9X missiles delivered to my house.

@Stalker1stVFW:

Roger that. If you want you can hop on my TS server and we can troubleshoot this. I fly with a buddy who’s a wiz kid at this stuff. If interested PM me

Cheers

Thank you for offer but frankly I have never tried that before. BTW, reran mission with MK82’s, no issue. thank you for you offer again though.

@Stalker1stVFW:

How long are you depressing the pickle button? Any lights on the fault panel? Did you over-G the jet enroute to the target? What was your Mach?

Can you drop all other unguided ordinance in any of those modes?

In CCRP I usually do approx. 1-2 seconds before the cue hits, never had a problem with other weapons. In CCIP and DTOS I understood to pickle and hold when the PUAC starts flashing until the cue hits. I tried that and also simply 1-2 seconds before it should release. No luck. No Over G enroute or otherwise at all, no lights, was anywhere from 370-425 Knots but in level flight (not sure of the mach). There were no other weapons attached to try. This was first time I had ever used MK82SE’s though.

Flying in a campaign. Master ARM on. Have 6 MK82SE’s that I have set for ripple 3 in pairs. Did CCRP, no release. Tried DTOS, no release, CCIP no release. Have met all parameters, have fuse set short so no issue there. Is this a bug or am I just doing something still wrong? (which for the life on me I cannot figure out!)

@anthonc9647:

Hello! Just finished my first campaign on tiger spirit. all objectives are captured and I completed a mission and came back to 2D and the clock has stopped and will not continue on, nor will it give me any updates or tell me that I’ve completed it… any suggestions?

It is because your campaign has ended, just as you said. Check your logbook and you’’ likely see that the won/lost/tied category has changed. And do not be alarmed to see that it gave you a tie although you’ completed the win category of objectives, that is not unusual.