Better graphics and vr support.
Enviado desde mi ONEPLUS A6013 mediante Tapatalk
Better graphics and vr support.
Enviado desde mi ONEPLUS A6013 mediante Tapatalk
And …can you ramp start with that cockpit??
Enviado desde mi ONEPLUS A6013 mediante Tapatalk
OK not even sure about this one as I’ve never seen this happen before. Two of us in the same flight had issues and had to reset and reconnect to the server which was still running. We reconnected just fine and the aircraft were already running. The problem was the throttle was completely non-responsive to inputs. We both did the same thing of exiting the server and comms and checking our configurations and both of us were getting proper responses in 2D. I then went into Instant Action to verify throttle response and it was fine in IA. I then reconnected to the server and committed to the flight again. Entered 3D and once again no throttle control. We had started this one as a ramp start. I ramp started with zero issues. I had to reconnect after the jet was good to go since I use TARGET and I think my USB hub is starting to die so it will randomly disconnect and reconnect. That reset throws TARGET for a loop and forces me to go back to the desktop. The other pilot missed the oil condition start and fried the engine and he had tried to do the older school restart to fix it. This one was REALLY weird.
I had same problem last night. Online session with eleven pilots. After several attempts I decided to enter in flight but the AI could not start the f16. Therefore aborted mission.
Enviado desde mi ONEPLUS A6013 mediante Tapatalk
Yes, works fine!!
Enviado desde mi ONEPLUS A3003 mediante Tapatalk
I do not propose anything… Only wanted to know if someone knew why HL does not support Falcon bms.
Enviado desde mi ONEPLUS A3003 mediante Tapatalk
They dont answer since 2012…[emoji852]️
Enviado desde mi ONEPLUS A3003 mediante Tapatalk
My question is simple. Why bms is not supported by hyperlobby?
Thanxs in advance
Enviado desde mi ONEPLUS A3003 mediante Tapatalk
Had the values of x and y in -3200, I changed them to 0 0 and solved the problem, thanks roccio again
Enviado desde mi LG-D855 mediante Tapatalk
Are you using 32 or 64 bit version?
Are you using 1.0.0 or 1.1.0 version?
Check in /yame64/config/yame64.xml in notepad and see what value is set in . Sometimes it seems x or y is set to -3200, so it’s rendered outside the window.
Windows aeroglass disabled might cause issues.
Enabling “trama S3TC” in OpenGl Texture compression might cause issues.
64bit and the latest version….will check the folder later…thanxs for your quick answer…
Enviado desde mi LG-D855 mediante Tapatalk
The application runs but is minimized in the taskbar and I can not maximize. Does the same thing happen to someone? Any suggestions ??
My pc runs on win10.
Enviado desde mi LG-D855 mediante Tapatalk