measured pot resistance = 85.2K (86K value)
Still looking for specs required for TM PCB circuit ,
Hall sensor (measured by watts) voltage input / output
measured pot resistance = 85.2K (86K value)
Still looking for specs required for TM PCB circuit ,
Hall sensor (measured by watts) voltage input / output
Thank you Lucky, have sent an email for availability.
Today I will solder the wires to the sensor,
see if there is any change.
during assembly of soderless connectors, I had difficulty with one,
Maybe there is a faulty connection.
If not I will order from ViperGear, Looks interesting…
sent an inquery of delivery information. [$75.00 for X and Y}
(Stock Item or Backordered) [direct replacement (no mod)]
Mean while I am Modeling the Stock sensor, and researching possibilities.
Looking for the value, used by thrustmaster, of the POT / Hall sensor…… :mrgreen:
Well X axis is no good :mad:
Anybody Know where I can find a solution,
Looking for a replacement or Hall sensor to repair my cougar stick?
HOW TO INSTALL THE + HS2 MK II HALL SENSOR JOYSTICK KIT
cougar stick is spiking to the left
Would anyone have a copy of this procedure?
I have the parts, and probably could figure it out.
But a guide is always best.
I have tried the web archive site but photos are unavailable
Thanks
I was wondering if there is a statement to generate two controls at the same time?
something like this, maybe?
BT1 = /H com1 ; com2
Looking for both to be held for the same duration
Thank You :bowd:
Hello,
I was looking for a replacement part in the throttle.
Would this part be available somewhere?
the end retainer ring, holding handle in place.
Thank you
Yogi 20thVFW
Anyone have landing gear sink into deck on vinson
I have launched from the catapult (CATII) with half the F/A-18C in the deck
noticed in U5