Profile for T Warthog + T rudder pedals + 2 T MFD needed please
-
I am new user of Thrustmaster Hotas Warthog (stick and throttle) + Thrustmaster rudder pedals + Thrustmaster MFD (thats the newest part of my equipment). First I used Warthog + pedals without target profiles and configure everything inside Falcon
s setup. It worked fine. But now I would like to use full potential of my hardware and try to upload profile via Target software. I started with Mud
s profile, but without effect, then with Rybo`s V 2,5 - stick and throttle works, but without rudder.
Could anybody help me please and send good profile for such hardware?
I will be gratefull fo help. -
Morphine’s profile works with MFD’s and rudder pedals. You will have to bind the pedals in game. The target script and keyfile can be downloaded from here. https://www.dropbox.com/sh/66rd8borl2zrfbd/AAAnvz5u93ebm0Tzh322Vw6ba?dl=0
-
Morphine’s profile works with MFD’s and rudder pedals. You will have to bind the pedals in game. The target script and keyfile can be downloaded from here. https://www.dropbox.com/sh/66rd8borl2zrfbd/AAAnvz5u93ebm0Tzh322Vw6ba?dl=0
Hey, is there any tutorial on how to “install” those?
-
-
I am new user of Thrustmaster Hotas Warthog (stick and throttle) + Thrustmaster rudder pedals + Thrustmaster MFD (thats the newest part of my equipment). First I used Warthog + pedals without target profiles and configure everything inside Falcon
s setup. It worked fine. But now I would like to use full potential of my hardware and try to upload profile via Target software. I started with Mud
s profile, but without effect, then with Rybo`s V 2,5 - stick and throttle works, but without rudder.
Could anybody help me please and send good profile for such hardware?
I will be gratefull fo help.Hey I’m new to this too. Just got the same set up as you have, Warthog HOTAS plus TM rudders. I was using Muds profile for about a week before my rudder pedals showed up and was disappointing when they didn’t just “plug and play”. But if you go into the BMS 4.33-Mud TMC file and delete the “//” in front of “Configure(&TFRPRudder, MODE_EXCLUDED);” , and save it, it will allow the pedals to be recognized.