Hand throttle possible bug
-
reason why I say possible im not 100% sure if its on my side or not.
Version
4.34.0 (x64)Build
19631Detailed Description
the HOTAS i have is a Saitek X52, now I tested the Idle cut off option both on and off in the config option on start up of falcon. the odd thing is that when I have it enabled the FTIT goes over 800 degrees with out me giving any gas when the sec light goes out. when I have the idle cutoff disabled, it stays at 20 idle power like it should and doesnt over heat but I no action of my throttle even when i set the idle. I followed and read the 3.5.3 HOT START section of the new Manuel and im not ruling out that ive done something wrong. Im super excited with this new update and on top of it I got a head tracker, the amount of excitement i have I can barely hold it in. you guys did a awesome job with this and I just wanna thank you for doing an amazing job!Pictures
NoneExample files
noneCrash logs
noneReproducibility Procedure
electric panel : PWR = MAX PWR
ENG Feed = Norm
Air Source = Norm
…ect
Expected Behavior -
the HOTAS i have is a Saitek X52, now I tested the Idle cut off option both on and off in the config option on start up of falcon. the odd thing is that when I have it enabled the FTIT goes over 800 degrees with out me giving any gas when the sec light goes out.
This is because you do not have the throttle configured properly for idle cutoff enabled. This is the option I use with my Warthog setup and it behaves identically as it did in 4.33.
when I have the idle cutoff disabled, it stays at 20 idle power like it should and doesnt over heat but I no action of my throttle even when i set the idle. I followed and read the 3.5.3 HOT START section of the new Manuel and im not ruling out that ive done something wrong.
It should get up to 25% before it stops. You either aren’t triggering the idle detent or your throttle isn’t configured properly for the second case.