Throttle warthog bad calibration
-
After uninstalling the warthog I have problems with the calibration.
It is not recognized Z-axes zone and rot-Z-axis before the detent of the idle cutoff. Basically I can not set the IDLE CUTOFF.
I tried to calibrate with windows and tools “Warthog Throttle Calibration (V1.07)” without success.
I uninstalled both whartog the Target cleaning registers.
I installed the whartog on another laptop with the same problem.
I reloaded the firmware without success.
Other suggestions? -
It’s because the iddle cutoff position is not axis but it’s kinda button, you can program it in TARGET as “alt+I” for iddle off position, for iddle on position you have to set some delay (about 3 secs). This works fine for me.